Installing Devices
1. Remove buttons from packaging.
2. Check for the ID # on the sticker on the back of the button. On this sticker you will see an ID number. This ID number will already be programmed into the console. Use the programming sheets to associate each station's ID number with the correct room placement.
NOTE: You may receive have extra buttons depending on the number of rooms at your clinic. If you have any couples rooms or rooms with more than one massage table then extra devices will need to be reprogrammed to these rooms.
3. After determining the corresponding room for each button you will need to install them on the massage tables. Start with mounting the "Station Bracket" that comes with the Attention Button (WNC-SB) to the T-Bracket. After attaching the station bracket to the T-Bracket then snap the attention button onto the station bracket.
4. The attention bracket should then be installed 20 inches from the head of the massage table with the button pointing out toward the wall.
NOTE: When attaching the bracket you will need to seat the bracket 0.5 inches back on the lip of the table so that the button does not protrude too far from the edge of the table (see picture below).